FAQ

Inside the tunnel boot – Passenger side ( * if passenger side is blocked then you find it in driver side)
If your caravan housing Battery voltage is very low your 240V Battery charger will not detect the battery, So best option is to connect the caravan’s Anderson plug into the car and run the car for about 15 minutes. Then put 240V ( AC Current ) in the van.

If your Hitech 2000W inverter is not working you can bypass your inverter quite easily. 


• Turn off 240V circuit brakers. (* If you have two breakers turn both OFF)
• Locate your Inverter ( Under the seat, under the bed, under the Fridge or inside the kitchen)
• Pull 240V input plug from the Plug point. (This cord is similar to a computer power cord )
• Pull 240V out put plug from the inverter and plug into the wall plug point. (This plug is attached to one of the two 240V output of the inverter) 

If your Hitech 2000W inverter is not working you can bypass your inverter quite easily. 


• Turn off 240V circuit brakers. (* If you have two breakers turn both OFF)
• Locate your Inverter ( Under the seat, under the bed, under the Fridge or inside the kitchen)
• Pull 240V input plug from the Plug point. (This cord is similar to a computer power cord )
• Pull 240V out put plug from the inverter and plug into the wall plug point. (This plug is attached to one of the two 240V output of the inverter) 

• Make sure battery compartment is clean free of dust and moisture.
• If your caravan has got more than one battery charge each battery individually up to maximum capacity every two months.
• Check all Battery terminals, cables clean and fasten.
• Check your battery charger is free of dust and proper working order. 

Sometime if the surround of the hatch is not clean enough, hatch won’t seal 100% when it is closed. Make sure surrounding of the hatch lid ( from roof top) if clean and free of leaves and other particles before you close the lid.
If still leaking, please your dealer.